Schaeffler Product catalogue - medias
Ihre Eingaben des Auswahlassistenten werden im Hintergrund gespeichert, Sie können den Assistenten jederzeit wieder aufrufen.
(0)

TSWWA25


Guideways

solid profile, for location from above, with one raceway shaft; corrosion-resistant design possible

  
Send to shopping basket
 
dLW 25  mm  Tolerance: h6
h4 42  mm  Tolerance: +/-0,02

In relation to the nominal shaft diameter, measured whilst clamped.
b 60  mm   
lmax 6000  mm  Tolerance: +/-3

Maximum length of single-piece shaft and support rail units; longer units are supplied in several sections.
Depending on the length of the shaft and support rail unit, the rail is composed of several individual sections.
5)   The shaft protrudes beyond the support rail by approx. 2 mm on each side.
aL max 110  mm  aL and aR are dependent on the guideway length
aL min 20  mm  aL and aR are dependent on the guideway length
aR max 110  mm  aL and aR are dependent on the guideway length
aR min 20  mm  aL and aR are dependent on the guideway length
b3 10,4  mm   
b4 14  mm   
H8 6  mm   
jB 42  mm   
jL 120  mm   
K3 6,6  mm  for fixing screws to ISO 4762 or ISO 4017
If there is a possibility of settling, the fixing screws should be secured against rotation.
K7 M8x30  ISO 4762
mS 5830  g/m  Mass of guideway
Schaeffler applies cookies to secure an optimal use. With the further use of this website you accept the application of cookies.  Further information