Schaeffler Product catalogue - medias
Ihre Eingaben des Auswahlassistenten werden im Hintergrund gespeichert, Sie können den Assistenten jederzeit wieder aufrufen.
(0)

7602012-TVP


Axial angular contact ball bearings

single direction, with contact angle α = 60°, restricted tolerances

  
Send to shopping basket
Radial loadAxial load in one directionNot sealedGrease lubrication
Design of housing and shaft (threaded spindle)
Design of housing and shaft (threaded spindle)
(4) Only valid in assembled condition
 
d 12  mm  Tolerance: 0/-0,004
D 32  mm  Tolerance: 0/-0,006
B 10  mm  Tolerance: 0/-0,08
  60  °  Contact angle
a 24  mm 
Da 27  mm  Tolerance: H12
da 17  mm  Tolerance: h12
r1 min 0,6  mm 
rmin 0,6  mm 
m 0,042  kg  ≈ Mass
Ca 12200  N  Basic dynamic load rating, axial
C0a 20700  N  Basic static load rating, axial
Cua 940  N  Fatigue limit load, axial
nG Fett 14100  1/min  Limiting speed for grease lubrication
nϑ 8000  1/min  Thermally safe operating speed
MRL 0,015  Nm  Bearing frictional torque
Valid for single bearing with stated preload force.
Bearing lightly oiled.
caL 476  N/µm  Axial rigidity
Valid for matched pair of bearings in O or X arrangement
  2  µm  Axial runout
The axial runout data for screw drive bearing arrangements are based on the rotating inner ring.
  ZM12  Recommended INA precision locknuts with radial clamping

The recommended INA precision locknuts are not included in the scope of delivery and must be ordered separately.
MA 8  Nm  Tightening torque

Only valid in conjunction with INA precision locknuts.
Observe the guidelines on locating/locating bearing arrangements.
  6110  N  Requisite locknut force, axial

The requisite axial locknut force must be observed when using other locknuts.
Schaeffler applies cookies to secure an optimal use. With the further use of this website you accept the application of cookies.  Further information